(OLD VERSION) Offline & Sensor Calibration
How to fix sensor calibration issue in Valpas system
Last updated
How to fix sensor calibration issue in Valpas system
Last updated
When performing sensor calibration tasks, the legs do not blink or provide any indication of which leg is currently experiencing an issue. Therefore, you will need to manually check each leg to determine which one has the issue.
To reset the module, remove the batteries and then re-insert them.
Ensure that the module is firmly attached to its place when connecting it to the leg, and watch for three blinks of the red light as confirmation of successful attachment.
Always remember to when removing the module.
The leg number displayed in the dashboard app should match the Serial Number (Sn) indicated in the module.
After completing the tasks mentioned above, the issue should be resolved, and the legs should be displayed in green color on the dashboard app. ()
If the issue still persists and is shown in the app even after 4 hours, please for further assistance.