Offline & Sensor Calibration
How to fix sensor calibration issue in Valpas system
Find the leg with correct serial number
When performing sensor calibration tasks, the legs do not blink or provide any indication of which leg is currently experiencing an issue. Therefore, you will need to manually check each leg to determine which one has the issue.
Always remember to transfer the contents of the module to the inspection jar when removing the module.
Remove and re-insert the batteries
To reset the module, remove the batteries and then re-insert them.
Clean the module and then re-insert it into the leg
Use a cotton swab to clean the inside of the module.
Re-attach the module to the leg
Ensure that the module is firmly attached to its place when connecting it to the leg, and watch for three blinks of the red light as confirmation of successful attachment.
Check that the issue is not presented in the dashboard app
Due to the nature of the system, it may take between 1 to 60 minutes for the issue to be resolved and reflected in the dashboard app.
After completing the tasks mentioned above, the issue should be resolved, and the legs should be displayed in green color on the dashboard app. (Rooms view)
If the issue still persists and is shown in the app even after 4 hours, please contact our support team for further assistance.
Last updated
